When servicing Aplus units, what must be done with cycle valves for automatic valves?
Aplus Franchise · 2024 FDDAnswer from 2024 FDD Document
| Annual Service Call Frequency | 3X | |---|---| | Compressor Maintenance (Basic) | | | Visually check for leaks. | X | | Check and record suction & discharge pressure, oil pressure, room & ambient | X | | temperature. | | | Air Handling Unit (AHU) Maintenance (Basic) | | | Install standard filters | X | | Leave at site three additional sets of filters for site personnel to change each month. | X | | Check electrical wiring and connections. Tighten loose connections. | X | | Check and record amperage across blower motor. | X | | Check tension, condition and alignment of belts. Adjust as necessary. | X | | Lubricate shaft and motor bearing. | X | | Condenser Maintenance (Basic) | | | Check and record amperage across condenser fan motor. | X | | Check electrical wiring and connections. Tighten loose connections. | X | | Clean condensate lines and pans. | X | | Check contactors and starters. | X | | Cooling Maintenance (Spring only-May) | | | Power wash condenser coil(s) and clean evaporator coil(s). | X | | Change all belts. | X | | Annual asset inventory report and analysis. | X | | Heat Maintenance (Fall only-November) | | | Verify pilot ignition-check for proper operation of primary fuel controls and safety | X | | controls. Check and adjust thermostat. Check pump pressure (fuel oil). | | | Check and clean flue. Replace oil filter and nozzle. | X |
| Cycle valves-for automatic valves (check valves)-adjust system pressure/flow to verify that valve is opening and closing properly. For manual valves (Gate/Butterfly)-open and close using handle, wrench, or hand wheel to check operation. Check draft and smoke reading. | X |
Source: Item 23 — RECEIPT (FDD pages 68–302)
What This Means (2024 FDD)
According to Aplus's 2024 Franchise Disclosure Document, when servicing Aplus units with automatic valves, specifically cycle valves, the system pressure and flow must be adjusted to verify that the valve is opening and closing properly. This is part of the routine checks and maintenance to ensure the equipment operates as intended. For manual valves, the procedure involves opening and closing the valve using a handle, wrench, or hand wheel to check its operation. Additionally, the draft and smoke reading should be checked.
This requirement ensures that the automatic valves are functioning correctly, which is crucial for maintaining the efficiency and safety of the Aplus store's equipment. By adjusting the system pressure and flow, technicians can identify and address any issues that may prevent the valves from opening and closing as they should. This proactive approach helps prevent potential problems and ensures that the equipment operates within the specified parameters.
For a prospective Aplus franchisee, this means that regular maintenance checks, including the adjustment and verification of cycle valves, are a necessary part of operating the franchise. Franchisees should ensure that their maintenance personnel are trained to perform these checks accurately and efficiently. Proper maintenance not only prolongs the life of the equipment but also helps in maintaining a safe and efficient operation, which can contribute to customer satisfaction and overall business success.